Cut-out 3D model of Eyjafjallajökull volcano, Iceland

A simple schematic model of the Eyjafjallajökull volcano summit, crater and ash plume as seen on Blue Peter's Make It.

It is intended as a simple guide to understanding how volcanoes such as Eyjafjallajökull are influenced by tectonic plate activity along the Mid-Atlantic Ridge.

It also shows the route of the floodwater from melted glacier ice to the sea.

The model is not to scale. The height of the volcano is highly exaggerated.

The Mid-Atlantic Ridge.

Download and assembly instructions

  1. Download cut-out 3D model of Eyjafjallajökull 2MB pdf
  2. Print the two pages of the pdf to an A4 printer — heavy weight paper or card works best.
  3. Cut around the three parts of the model — you may need to get an adult to help you.
    1. Ash plume
    2. Base
    3. Summit and crater
  4. Ash plume: fold and glue the two halves together.
  5. Base: cut out the hole in the middle of the base.
  6. Base: fold along the thick black lines and glue tabs to make-up the model like a box lid. Allow to dry.
  7. Summit and crater: fold as shown in the images below. Half the 'cone' points downwards.
  8. Glue the summit and crater to the base as shown in the image below. This is the tricky bit!
  9. Glue the ash plume to the summit and crater.

What you will need:

 Equipment
Making up the base and ash plume Base and ash plume
Folding the summit and crater Summit and crater
Summit and crater assembled Summit and crater assembled
Finished model Finished model

Further information

Contact Enquiries for further information.